Selecting Multiple Subsystems; Summary - HP 54501A Programming Reference Manual

Selecting Multiple
Subsystems
You
can send
multiple program
commands and program queries
for
different subsystems on the same line by
separating each command with
a
semicolon.
The colon following
the semicolon enables you to enter
a new
subsystem.
For
example:
< program mnemonic > <
data
>;: < program mnemonic > < data > < terminator
>
:CHANNEL1:RANGE 0.4;:TIMEBASE RANGE
1
Note
Multiple commands may
be
any combination
of compound
and
simple commands.
Summary
The following
illustration summarizes the syntax for programming over
the
bus.
PROGRAM MESSAGE UNIT
DATA
OUTPUT
XXX;
" .-SYSTEM: HEADER ON"
T COMMAND
————————————————————
E ADDRESS
—————————————————————————
AM MNEMONICS
——————————————————————————————————————————
ATOR
——————————————————————————————————————————————————
Introduction to Programming an Oscilloscope
1-10
HP
54501A
Programming