Table of Contents
Advertisement
User Manual | Mitchell Diagnostics | Scan Tool | 18 | en
Diagnostic Functions
ss02827
MAIN MENU - Tap Below To Begin Your Diagnostic Experience
Select Vehicle
Heavy Duty
Today is Thu, 04 Jan 2018.
1. Select OBD-II from the Main Menu screen.
2. Follow the prompts on the screen.
Readiness Monitors
Mode 1 displays available monitor information.
The OBDII system has a series of systems that run
self-tests. These systems or components have to be
made ready by either turning on the ignition or
manipulating the system in some other manner. This
is called drive cycle.
Each system requires specific vehicle drive cycle and
operating requirements to take place before the
monitor self-check will run. OBDII systems require
one monitor for current systems, or two monitors for
older systems, are ready before testing can begin.
If the system is ready, no further action is required.
If the system is not ready, a drive cycle may need to
be performed for that system.
Use the following procedure to verify the system is
ready to be monitored.
ss02718
Generic OBDII
READINESS MODE 1
Readiness (Mode 1)
DATA STREAM MODE 1
Monitor Description
FREEZE FRAME MODE 2
A/C System Refrigerant Monitor
DTCs MODES 3, 4, 7, A
EGR System Monitor
O2 SENSORS MODE 5
Catalyst Monitor
NON-CONTINUOUS TESTS
Heated Catalyst Monitor
MODE 6
SPECIAL TESTS MODE 8
Misfire Monitor
VEHICLE INFO MODE 9
1. View the readiness table to verify system status.
• Ready: No further action is required.
• Not ready: Further action is required. Drive
©Mitchell International, Inc.
OBDII
Saved Diagnostic Data
Settings
Share
Status
Not Supported
Ready
Ready
Ready
Not Supported
Cycle needs to be performed.
• Monitor not supported: Data is not supported
on vehicle.
9:40
•
Readiness Mode Button Definitions
Menu Button
Tapping the Menu button displays a
Browser
pop-up link that takes the user to more
buttons.
View Help
Selecting View Help will open an online
user manual.
Use Metric Units
Selecting Metric Units will switch from
English/Standard Units to Metric Units
Use English/Standard Units
Selecting English/Standard Units will
switch from Metric Units to English/Stan-
dard Units.
Take Screen Capture
Selecting Take Screen Capture will save a
copy of the current open screen.
Data Stream
Mode 1 views live vehicle sensor data.
The data stream function shows live sensor and
solenoid data streaming from the vehicle's electronic
control unit (ECU).
ss02719
Generic OBDII
READINESS MODE 1
DATA STREAM MODE 1
FREEZE FRAME MODE 2
DTCs MODES 3, 4, 7, A
O2 SENSORS MODE 5
Menu
NON-CONTINUOUS TESTS
MODE 6
SPECIAL TESTS MODE 8
VEHICLE INFO MODE 9
1. Select Data Stream Mode 1 from the Generic
OBDII screen.
TAP 'DATA STREAM MODE 1' TO REOPEN
581624 | REV. B | 06.2017 | APDMD032018
Menu
Advertisement
Table of Contents
