Removing Modules
When removing a module, follow the steps shown below:
▪
If there is a module label present, remove it (A-1, below).
If the module has more than one Terminal Strip, all of the these must be
removed. The following describes how a single-slot module is removed.
Lift the Terminal Strip by pressing on the connector latch (A-2).
▪
Remove the Terminal Strip (B).
▪
Remove the left-adjacent and right-adjacent Terminal Strips of the neighboring
modules (C). This prevents the potential routing featherkeys and the
keyway/featherkey connection from being damaged and creates more space
for accessing the module.
▪
Press the release mechanism, and remove the module from the DIN rail by
pulling it straight back (D-2).
▪
To remove the NIU, the left end clamp must be removed first.
Replacing a Module
If you want to replace a module within the VersaPoint station, reverse the removal
procedure above.
GFK-1911B
Chapter 4 Installation
4
4-9