Eoi Remote Mounting; Remote Eoi Required Hardware; Eoi Installation Precautions; Appendix C - Toshiba H7 Operation Manuals

Appendix C

EOI Remote Mounting

The H7 ASD may be controlled from a remote position via the EOI. For safety and application-specific
reasons, some ASD installations will warrant that the operator not be in the vicinity during operation or
that the EOI not be attached to the ASD housing. The EOI may be mounted either with or without the
optional H7 Remote Mounting Kit (P/N ASD-MTG-KIT). The ease of installation is enhanced by the H7
Remote Mounting Kit which allows for easier cable routing and EOI placement.
The EOI may be mounted up to 15 feet away from the ASD and will provide the full range of functions
that are available if the EOI were ASD-mounted.
Remote mounting will also allow for multiple EOI mountings at one location or one EOI may be switched
between multiple ASDs. Controlling and monitoring several ASDs via an EOI may be accomplished from
a central location.
The optional dust cover (P/N ASD-BPC) may be used to cover the front panel opening of the ASD
housing after removing the EOI. An EOI extender cable is required for remote mounting. EOI extender
cables are available in lengths of 7, 10, or 15 feet and may be ordered through your sales representative.

Remote EOI Required Hardware

EOI Mounting Hardware
• 6-32 x 5/16" Pan Head Screw — P/N 50595 (4 ea.)
• #6 Split-Lock Washer — P/N 01884 (4 ea.)
• #6 Flat Washer — P/N 01885 (4 ea.)
Bezel Plate Mounting Hardware
• Bezel Plate — P/N 52291
• 10-32 Hex Nut — P/N 01922 (4 ea.)
• #10 Split-Lock Washer — P/N 01923 (4 ea.)
• #10 Flat Washer — P/N 01924 (4 ea.)
• Dust Cover — P/N ASD-BPC (Optional)
Extender Cables
• ASD-CAB7F: Cable, RJ45, 7 ft.
• ASD-CAB10F: Cable, RJ45, 10 ft.
• ASD-CAB15F: Cable, RJ45, 15 ft.

EOI Installation Precautions

Install the unit securely in a well ventilated area that is out of direct sunlight using the four mounting holes
of the EOI. The ambient temperature rating for the EOI is 14 to 104° F (-10 to 40° C).
• Select a mounting location that is easily accessible by the user.
• Avoid installation in areas where vibration, heat, humidity, dust, metal particles, or high levels of
electrical noise (EMI) are present.
• Do not install the EOI where it may be exposed to flammable chemicals or gasses, water, solvents, or
other fluids.
• Turn the power on only after securing the front cover to the ASD.
200 Appendix C H7 ASD Operation Manual