Measuring Channels, Indirect And Direct Measuring System - Siemens SINUMERIK 810DE powerline Equipment Manual

4 Description of the SINUMERIK 810D
4.3 Measuring system
4.3.3

Measuring channels, indirect and direct measuring system

Measuring
The six measuring channels on the SINUMERIK 810D can be used both for
channels for indirect and for direct position sensing. A free measuring channel can, for exam-
ple, be used for a direct spindle measuring system. Additional measuring chan-
SINUMERIK 810D
nels can be obtained by using a 611D standard control module with/without di-
rect measuring system.
Connecting
The following connecting cables are used for the SINUMERIK 810D:
cables
Table 4-15 Connecting cables for SINUMERIK 810D
No. MLFB
1 6FX2002-2CA31-1VV0
2 6FX2002-2CG00-1VV0
3 6FX2002-2CH00-1VV0
4 6FX2002-2CA1 1-1VV0
5 6FX2002-2AD00-1VV0
6 6FX2002-2EQ00-1VV0
7 6FX2002-2EQ10-1VV0
1)
Length code, refer to Catalog NC Z
2)
Measuring system end circular connector
A number is assigned to each cable.
You will find these numbers (1-7) in the following figures.
Indirect
The motor measuring system is also used for position sensing.
measuring system
Two encoder systems are available:
FSD
S
S
4-66
1)
Motor measuring system cable incremental, 25-pole connector
1), 2)
Connecting cable for direct measuring system, 25-pole connector (for
connection to CCU only)
1), 2)
Connecting cable for Multiturn absolute EnDat encoder, 25-pole
connector (for connection to CCU only)
1)
Connecting cable for direct measuring system, 15-pole connector (for
connection to 611D control only)
1)
Connecting cable for Multiturn absolute EnDat encoder, 15-pole
connector (for connection to 611 control only)
1)
Motor measuring system cable absolute, 25-pole connector
1)
Motor measuring system cable absolute, 25-pole connector
Incremental encoder
Absolute encoder
SINUMERIK 810D Equipment Manual Configuration CCU (PHC) – 03/2006 Edition
Description
Copyright © Siemens AG 2006