Dr 4 - Scale Operating Mode (Scale Type) - Siemens SIWAREX FTA Device Manual

Weighing Functions
Name
Empty range REAL
Start-up weight limit REAL
value 1
Shut-down weight limit REAL
value 1
Start-up weight limit REAL
value 2
Shut-down weight limit REAL
value 2
Start-up weight limit REAL
value 3
Shut-down weight limit REAL
value 3
Through-put
Minimum through-put REAL
Limit value 1
Minimum through-put REAL
Limit value 2
Filter depth of BYTE
average value filter for
through-put calculation
Reserve 5 BYTE
Table 5-2 DR4 Allocation
5.4.1

DR 4 - Scale operating mode (Scale type)

This parameter is used to select the suitable weighing instrument program. One
of these weighing operating modes applies depending on the task description.
5.4.2 DR 4 - Type: weighing (additive)
Non-automatic weighing instrument – according to OIML R-76 – only accepts
service and adjustment commands and "zero setting" and "taring" weighing
instructions. The net weight increases with increasing load on the scale. No dosing
functions are supported.
5.4.3 DR 4 - Type: weighing (subtractive)
Non-automatic weighing instrument – according to OIML R-76 – only accepts
service and adjustment commands and "zero setting" and "taring" weighing
instructions. The net weight increases with decreasing load on the scale.
No dosing functions are supported.
5-62
Type Address Default
DBD012 1
Wizzard:
WB
max
DBD016 1
Wizzard:
WB
max
DBD020 1,1
Wizzard:
WB
max
1
DBB024 50
Wizzard:
WB
max
DBB028 49
Wizzard:
WB
max
DBB032 99
Wizzard:
WB
max
DBB036 98
Wizzard:
WB
max
DBB040 0
DBB044 0
DBB048 5
DBB049 0
50
Range of Values / Explanation
For filling procedures this depends on
parameters, for emptying procedures relative to
*0,01 gross
*0,01
*0,01
*0,5
*0,49
Limit value 3 corresponds with overfill limit
*0,99
*0,98
0: No monitoring
> 0 minimum through-put [1/sec]
0: No monitoring
> 0 minimum through-put [1/sec]
[0...255] X 10 msec
Reserve 5
Reference
5.5.14
5.5.15
5.5.16
5.5.17
5.5.18
5.5.19
5.5.20
5.5.21
5.5.22
5.5.23
SIWAREX FTA