Dr3 - Numeral Step For Weighing Range 1 - Siemens SIWAREX FTA Device Manual

5.2.16 DR3 - Numeral Step for weighing range 1

The numeral step for weighing range 1 can be defined according to standard
EN 45501 (0.0001 to 50)
5.2.17 DR3 - Minimum weight for weighing range 2
The weight value can be used for calibratable recording with the numeral step for
measurement range 2 only above the minimum weight. The minimum weight is
defined by an adjustment or a calibration. The minimum weight depends on the
number and type of load cells used.
The value can be set to 0 on non-calibratable scales.
Note
If only one range is defined then this entry is meaningless.
5.2.18 DR3 - Maximum weight for weighing range 2
The weight can be used for calibrating purposes with the numeral step for
measurement range 2 only under the maximum weight. The maximum weight is
defined with the adjustment.
The maximum weight depends on the number and type of load cells used.
Note
If only one range is defined then this entry is meaningless.
5.2.19 DR3 - Numeral step for weighing range 2
The numeral step for weighing range 2 can be defined according to standard
EN 45501 (0.0001 to 50)
If only one range is defined then this entry is meaningless.
5.2.20 DR3 - Minimum weight for weighing range 3
The weight value can be used for calibratable recording with the numeral step for
measurement range 3 only above the minimum weight. The minimum weight is
defined by an adjustment or a calibration. The minimum weight depends on the
number and type of load cells used.
The value can be set to 0 on non-calibratable scales.
Note
If only one or two ranges are defined then this entry is meaningless.
SIWAREX FTA
Weighing Functions
5-53