Table of Contents
Advertisement
Installation Manual – BTS3606 Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
3.2.2 Installing or Removing Side Doors
To install the side door, proceed as follows:
1)
Align the side door with the positioning pin on one side of the cabinet.
2)
Install the six captive screws on the side door.
Note:
Be careful of the protection grounding cables when installing or removing the side
doors.
3.2.3 Installing or Removing Left-Front and Right-Front Doors
The following describes the installation of the left-front door, and the installation of the
right-front door is same with it.
To install the left-front door, proceed as follows:
1)
Remove the positioning pin base on the top of the cabinet. (The positioning pin on
the top of the cabinet is fixed on the positioning pin base.)
2)
Align the left-front door with the positioning pin on the left bottom of the front
cabinet.
3)
Match the positioning hole on the lower part of the left-front door with the
positioning pin on the front part of the cabinet base.
4)
Insert the positioning pin previously removed to the positioning hole on the upper
part of the front door.
5)
Fix the positioning pin base.
3.3 BTS3606 Cabinet Configuration
Figure 3-5 shows the BTS3606 cabinet configuration in the full configuration.
When the BTS3606 supports multi-channel configuration, the slots of the CTRMs are
configured with the CMTRs, and the slots of the CHPAs are configured with the
CMPAs.
The slots of the CCPMs in Figure 3-5 can also accommodate the CECM.
Chapter 3 Installing Cabinet and Cabinet Equipment
Huawei Technologies Proprietary
3-4
Advertisement
Table of Contents
