Installation Manual – BTS3606 Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
(1) M12 x 70 bolt
(4) Insulating washer
(7) Nut
Figure 2-7 Disassembling an expansion bolt
5)
Feed the tube and the nut into the hole vertically and make sure that the guiding
rib on the nut meets the guiding slot of the tube, as shown in Figure 2-8.
6)
Hammer the tube until it is completely buried in the ground.
Figure 2-8 Installing an expansion bolt
III. Fixing the Lower Support
To fix the lower support, proceed as follows:
1)
Place the insulating plate and the lower support in turn aligning with the four
expansion bolts.
(2) Spring washer
(5) Expansion tube
(8) Guiding rib
Huawei Technologies Proprietary
2-9
Chapter 2 Installing Cabinet Assemblies
(3) Plain washer
(6) Guiding slot