Table of Contents
Advertisement
User Guide: PTP 800 Licensed Ethernet Microwave
Configuring the CMU to generate email messages
Perform this task to enable the CMU to generate Simple Mail Transfer Protocol
(SMTP) email messages.
If SMTP is enabled, then the CMU will generate email messages to alert the system
administrator when certain events occur. The CMU may be configured to generate
Email messages for the following events:
x
Link status change
x
Diagnostic alarms
To configure SMTP email messages, proceed as follows:
Procedure 6-24 Configure SMTP messages
1
From the left hand menu, select Remote Management. The Remote
Management page is displayed
2
Update the SMTP attributes
3
Select Submit Updated Configuration. The Configuration Change Reboot
dialog is displayed
4
Select Reboot Wireless Unit. The Reboot Confirmation dialog is displayed
(Figure
5
Select OK. The reboot progress message is displayed. On completion, the
unit restarts.
NOTE
phn-1478_005v000
Apr 2010
(Figure
6-14).
If the 'Enabled Diagnostic Alarms' option is selected, ensure that the
required diagnostic alarms are enabled. For more information, see
Configuring generation of diagnostic alarms
(Figure
6-22).
(Table
6-18).
6-20).
Managing faults
on page 6-47.
6-49
Advertisement
Table of Contents
