User Guide: PTP 800 Licensed Ethernet Microwave
Saving and restoring system configuration
The save and restore feature allows the system administrator to save and restore
the operational configuration of the units. Motorola recommends that the
configuration should be saved immediately after a successful link installation and
immediately before a software upgrade. In the unlikely event that a unit has to be
replaced in the field, the replacement unit can be reconfigured by restoring the
saved configuration file.
Saving the configuration file
Perform this task to save the operational configuration of the units.
To save the configuration file, proceed as follows:
Procedure 6-13 Save configuration file
From the left hand menu, select Configuration, Save And Restore. The
1
Save & Restore Configuration page is displayed
Select Save Configuration File.
2
Save the configuration file to a PC hard drive.
3
The configuration file format is:
MAC-mm-mm-mm_IP-iii-iii-iii-iii.cfg
phn-1478_005v000
Apr 2010
Where:
mm-mm-mm
iii-iii-iii-iii
(Figure
Is:
Last three octets of unit MAC address
IP address of unit.
Upgrading the PTP 800
6-15).
6-31