Various Notification Settings; Snmp Trap Setup - Fujitsu ETERNUS AF250 S2 Configuration Manual

Chapter 6 Monitoring Settings
6.2

Various Notification Settings

6
Click the [Set] button to apply the specified settings.
A confirmation screen appears.
7
Click the [OK] button.
The event notification settings are applied.
8
Check the setting completion message and click the [Done] button.
The screen display returns to the [Event/Dump] screen.
6.2 Various Notification Settings
To monitor an ETERNUS AF, perform the required settings for device error notification.
6.2.1

SNMP Trap Setup

SNMP Trap can be sent to the SNMP Manager (monitoring server) when an event occurs in the ETERNUS AF.
The SNMP Trap setting is explained below.
Carefully read this manual and the manuals for the monitoring software (SNMP Manager) that is to be
used before monitoring the ETERNUS AF.
■
ETERNUS AF Settings
The SNMP Trap test setting is explained below.
1
Set up the network environment for the ETERNUS AF.
When the ETERNUS AF and the monitoring server are in different subnet environments, set the Gateway
IP address and the Allowable IP address (IP address of the monitoring server or the network address to
which the monitoring server belongs) on the [Setup Network Environment] screen of ETERNUS Web
GUI.
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
86
P3AG-1832-04ENZ0