Operation
Top line
Middle line
Bottom line
Top line
Middle line
Bottom line
54
Program cycle display
After the program has started, the program sequence can be followed
in the three-line display.
Vario TD Dental
Main wash 1
Time left
– Program name.
The following parameters can be checked using the arrow buttons
and :
– Current program block, e.g.
– Actual or required temperature
(depending on the display set, see "Additional settings/Display:
Temperature")
– A
value,
0
– Cycle number,
– Time left (in hours; under an hour, in minutes).
Program end
A program is usually finished when the following parameters and
messages are shown in the display:
– Program name.
Continuously alternating between:
– Parameter met/not met,
– A
value,
0
– Cycle number,
– Program finished.
In addition, the LED in the Start/Stop buttons goes out and the LED in
the button begins to flash. In the factory default state, an audible
tone also sounds for approx. 10 seconds (see "Settings/Volume").
45
Min
Main wash 1