Fujitsu ETERNUS CS800 S6 User Manual page 361

6. (Optional) In the Recovered Partition Name box, type a new name for the recovered
share. (The default name is the original share name.)
7. Click Apply.
The share is recovered on the source system. All data stored on the share at the time
the snapshot was saved is available.The original export protocol of the share (NFS or
CIFS/SMB) is retained in the recovery process.
If you previously remapped your backup application to a recovered share on the
target system, after you failback the share, you must remap your backup
application again to point to the source system.
Deleting a Snapshot
Delete a snapshot if it is no longer needed. After you delete a snapshot, it can no longer
be used to recover or failback a NAS share.
You cannot delete a snapshot if a failback operation is in progress for the
snapshot. Wait for the failback operation to complete, or abort the operation.
To delete a snapshot:
1. Do one of the following actions:
On the source system, disable replication for the share associated with the
l
snapshot (see
On the target system, delete the source system associated with the snapshot from
l
the list of allowed replication sources (see
260).
2. On the target system, select a snapshot in the Snapshots List and click Delete.
If you delete the last snapshot for a partition while replication for the
partition (to this target) is still enabled, any replicated data not yet
protected by a replicated share is not deleted. To delete this data, on the
source system, disable replication for the partition before deleting the last
snapshot.
3. Click Yes to confirm the action.
Recovery Jobs
The Recovery Jobs page allows you to view information about snapshot recover
operations that were previously completed.
To access the Recovery Jobs page, on the Receive NAS page, click the Recovery Jobs tab
(see "Recovery Jobs Page" on page
ETERNUS CS800
"Enabling Replication For a Share or Partition" on page
362).
"Deleting a Replication Source" on page
11.3 Receive NAS
350).
361