Milling Contour Spigot (Cycle63) - Siemens SINUMERIK 840D sl Operating Manual

Parameter Description
Machining
● Face C
surface
● Face Y
(only for Shop‐
● Face B
Turn)
● Peripheral surface C
● Peripheral surface Y
Clamp/release spindle (only for end face Y/B and peripheral surface Y)
The function must be set up by the machine manufacturer.
(only for Shop‐
Turn)
TR Reference tool Tool, which is used in the "stock removal" machining step. This is used
to determine the residual corners.
D Cutting edge number
Z0 Reference point in the tool axis Z
Z1 Pocket depth (abs) or depth referred to Z0 or X0 (inc)
CP Positioning angle for machining area
- (only for ShopTurn, machining surface, face Y)
Angle CP does not have any effect on the machining position in relation to the workpiece.
It is only used to position the workpiece with the rotary axis C in such a way that machining
is possible on the machine.
C0 Positioning angle for machining surface
- (only for ShopTurn, machining surface, peripheral surface Y)
DXY ● Maximum plane infeed
● Maximum plane infeed as a percentage of the milling cutter diameter
DZ Maximum depth infeed
Lift mode Lift mode before new infeed
If the machining operation requires several points of insertion, the retraction height can
be programmed:
● To retraction plane
● Z0 + safety clearance
When making the transition to the next insertion point, the tool returns to this height. If
there are no elements larger than Z0 (X0) in the pocket area, then Z0 (X0) + safety
clearance can be programmed as the lift mode.
10.5.12

Milling contour spigot (CYCLE63)

Function
You can use the "Mill spigot" function to mill any spigots on the face or peripheral surface.
Before you mill the spigot, you must first enter a blank contour and then one or more spigot
contours. The blank contour defines the area, outside of which there is no material, i.e. there,
Turning
Operating Manual, 05/2017, A5E40868721
Programming technology functions (cycles)
10.5 Contour milling
Unit
mm
mm
Degrees
Degrees
mm
%
mm
mm
535