HP FlexFabric 12500 Command Reference Manual page 43

Keepalive Interval : 15 sec
Msgs Sent/Rcvd : 288/426
KA Sent/Rcvd : 13/13
Label Adv Mode : DU
Reconnect Time : 120 sec
Loop Detection : On
Discovery Sources:
Targeted Hello 100.100.100.17 -> 100.100.100.20 (Active, Passive)
Hello Hold Time: 45 sec
GigabitEthernet3/0/2
Hello Hold Time: 15 sec
Label Acceptance Policy : prefix-from-20
Session Protection
State
Addresses received from peer:
202.118.224.20
1.2.3.4
Table 19 Command output
Field
Peer LDP ID
Local LDP ID
TCP connection
Session State
Session Role
Session Up time
Max PDU Length
Keepalive Time
Keepalive Interval
Msgs Sent/Rcvd
KA Sent/Rcvd
: On
: Ready
100.100.100.20 11.22.33.44
Description
LDP identifier of the peer.
LDP identifier of the local LSR.
TCP connection information of the session, including the IP addresses and
port numbers used by both ends of the TCP connection, and whether MD5
authentication is enabled for the TCP connection. If MD5 authentication is
enabled, MD5 On is displayed. If MD5 is not enabled, this field is blank.
State of the LDP session:
•
Non Existent—No TCP connection is established.
•
Initialized—A TCP connection has been established.
•
OpenRecv—LDP has received an acceptable initialization message.
•
OpenSent—LDP has sent an initialization message.
•
Operational—An LDP session has been established.
Role the local LSR in the session, Active or Passive.
Duration of the session in Operational state.
Maximum PDU length negotiated, in bytes.
Local—Maximum PDU length (in bytes) on the local LSR.
Peer—Maximum PDU length (in bytes) on the peer.
Keepalive time negotiated, in seconds.
Local—Locally configured Keepalive holding time, in seconds.
Peer—Keepalive holding time (in seconds) configured on the peer.
Keepalive interval in seconds.
Total number of LDP messages sent and received.
Total number of Keepalive messages sent and received.
38
Graceful Restart : On
Recovery Time : 360 sec
Path Vector Limit: 32
Hello Interval : 15000 ms
Hello Interval : 5000 ms
Duration : 120 sec
1.2.3.10