Display Mpls Ldp Parameter - HP FlexFabric 12500 Command Reference Manual

Field
In/Out Label
Nexthop
OutInterface
Related commands
display mpls lsp

display mpls ldp parameter

Use display mpls ldp parameter to display LDP running parameters.
Syntax
display mpls ldp parameter [ vpn-instance vpn-instance-name ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. The command displays the LDP running parameters for the specified VPN. If you
do not specify a VPN instance, the command displays LDP running parameters for the public network.
Examples
# Display LDP running parameters for the public network.
<Sysname> display mpls ldp parameter
Global Parameters:
Protocol Version
Nonstop Routing
Reconnect Time
Instance Parameters:
Instance ID
LSR ID
Loop Detection
Hop Count Limit
Label Retention Mode: Liberal
IGP Sync Delay
Table 17 Command output
Field
Global Parameters
Description
Incoming/outgoing label.
Next hop address for the FEC.
Outgoing interface for the FEC.
: V1
: Off Graceful Restart
: 120 sec Forwarding State Hold Time: 360 sec
: 0 Instance State
: 0.0.0.0
: Off
: 32 Path Vector Limit
Label Distribution Control Mode: Ordered
: 0 sec IGP Sync Delay on Restart
Description
Global parameters for all LDP-enabled networks.
35
: Off
: Active
: 32
: -