Configuration Procedure - HP 12500 Series Configuration Manual

Configuration procedure

Configure Switch A:
1.
# Enable IPv6.
<SwitchA> system-view
[SwitchA] ipv6
# Create VLAN 10.
[SwitchA] vlan 10
[SwitchA-vlan10] quit
# Configure port GigabitEthernet 3/0/3 to permit the traffic of VLAN 10 to pass through.
[SwitchA] interface GigabitEthernet 3/0/3
[SwitchA-GigabitEthernet3/0/3] port link-type trunk
[SwitchA-GigabitEthernet3/0/3] port trunk permit vlan 10
[SwitchA-GigabitEthernet3/0/3] quit
# Assign an IPv6 address to VLAN-interface 10.
[SwitchA] interface vlan-interface 10
[SwitchA-Vlan-interface10] ipv6 address 10::1/64
[SwitchA-Vlan-interface10] quit
Configure Switch B:
2.
# Enable IPv6.
<SwitchB> system-view
[SwitchB] ipv6
# Set the length limit for the match criteria in each ACL rule to 80 bytes. You must restart the switch
to validate the command.
[SwitchB] acl ipv6 enable
# Create VLAN 10.
[SwitchB] vlan 10
[SwitchB-vlan10] quit
# Configure ports GigabitEthernet 3/0/1 to GigabitEthernet 3/0/3 to permit the traffic of VLAN
10 to pass through.
[SwitchB] interface GigabitEthernet 3/0/1
[SwitchB-GigabitEthernet3/0/1] port link-type trunk
[SwitchB-GigabitEthernet3/0/1] port trunk permit vlan 10
[SwitchB-GigabitEthernet3/0/1] quit
[SwitchB] interface GigabitEthernet 3/0/2
[SwitchB-GigabitEthernet3/0/2] port link-type trunk
[SwitchB-GigabitEthernet3/0/2] port trunk permit vlan 10
[SwitchB-GigabitEthernet3/0/2] quit
[SwitchB] interface GigabitEthernet 3/0/3
[SwitchB-GigabitEthernet3/0/3] port link-type trunk
[SwitchB-GigabitEthernet3/0/3] port trunk permit vlan 10
[SwitchB-GigabitEthernet3/0/3] quit
# Enable ND snooping in VLAN 10.
[SwitchB] vlan 10
[SwitchB-vlan 10] ipv6 nd snooping enable
# Enable ND detection in VLAN 10.
286