Electronic On/Off - Motorola 6864115B62-C Detailed Service Manual

Controller Circuits
The voltage VSTBY, which is derived directly from the supply voltage by components R0621 and
VR0621, is used to buffer the internal RAM. C0622 allows the battery voltage to be disconnected for
a couple of seconds without losing RAM parameters. Dual diode D0621 prevents radio circuitry from
discharging this capacitor. When the supply voltage is applied to the radio, C0622 is charged via
R0621 and D0621. To avoid that the µP enters the wrong mode when the radio is switched on while
the voltage across C0622 is still too low, the regulated 5V charges C0622 via diode D0621.
J0601
13.2V
PASUPVLTG
FLT_A+
The voltage INT SW B+ from switching transistor Q0661 provides power to the circuit controlling the
audio PA output. The voltage INT SW B+ voltage is monitored by the µP through voltage divider
R0671 / R0672 and line BATTERY VOLTAGE. Diode VR0671 limits the divided voltage to 5.6V to
protect the µP.
Regulator U0611 is used to generate the voltage for the switched supply voltage output (SWB+) at
the accessory connector J0501 pin 13. U0611 is configured to operate as a switch with voltage and
current limit. R0611 / R0612 set the maximum output voltage to 16.5 volts. This limitation is only
active at high supply voltage levels. The regulator output is electronically enabled by a 0 volt signal
on pin 2. Q0661, Q0641 and R0641 are used to disable the regulator when the radio is turned off.
Input and output capacitors (C0603 and C0611 / C0612) are used to reduce high frequency noise.
Diode VR0601 acts as protection against transients and wrong polarity of the supply voltage.
Fuse F0401 prevents damage of the board in case the FLT A+ line is shorted at the controlhead
connector.
1.4

Electronic ON/OFF

The radio has circuitry which allows radio software and/or external triggers to turn the radio on or off
without direct user action. For example, automatic turn on when ignition is sensed and off when
ignition is off.
Q0661 is used to provide INT SW B+ to the various radio circuits and to enable the voltage
regulators via transistor Q0641. Q0661 contains an pnp and an npn transistor and acts as an
electronic on/off switch. The switch is on when the collector of the npn transistor within Q0661 is low.
When the radio is off the collector is at supply voltage level. This effectively prevents current flow
Accessories
PA, Driver
20 Pin Connector
Antenna Switch
16.5V
SWB+
Limiter
Ignition
ON / OFF
Emergency
Control
ON/OFF
9V3
9.3V
Regulator
PCIC,
Audio PA
TX Amp
Temp Sense
RX RF Amp
5.6V
IF Amp
VSTBY
Figure 2-1 DC Power Distribution Block Diagram
Controlhead
Option Board
12 Pin Connector
40 Pin Connector
FLT_A+
5VD
6V 5V
Regulator Regulator
5V
Regulator
5VD
MCU
ASFIC_CMP
µP, RAM,
FLASH & EEPROM
5V_RF 5V/
VDDA
FRACTN
VCOBIC
1-3