ELECTRICAL INSTALLATION
Terminal Identification
CAUTION:
FASTPATH:
1
2–12
All the terminal strips are labeled with a two-character identifier. The first character
identifies the module slot position and the second character identifies the terminals within
the module.
Make sure that the first character on the terminal strip corresponds to the slot location
identified on the chassis silkscreen.
Terminal Connections
When installing two lugs on one terminal, both lugs must be "right side up" as shown in the
picture below. This is to ensure the adjacent lower terminal block does not interfere with
the lug body.
Figure 2-14: Orient the Lugs Correctly
2
Figure 2-15: Correct Installation Method
3
845 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 2: INSTALLATION
SCREW
WASHER
LOWER
TERMI AL
TERMI AL
BLOCK
DIVIDER