DEVICE
4–54
•
Note that a Report control block can also be added by right clicking on "845" which is
under the GEDevice "tree".
The "Remove Report" button deletes an existing Report control block.
Note that the Report can also be deleted by right clicking on the configured existing
report.
•
Save button and Cancel button: Click the Save button to save all configured settings.
Click the Cancel button to discard the modifications just made to the configuration.
Add Report Control Block
1.
Click on the "Add Report" button.
The button is available in the lower side of the screen and is used to add a report
control block. (a Report can also be added by right clicking on "845" under GEDevice
"tree".)
The "New Report Control Block" window appears.
Figure 4-14: New Report Control Block Window
845 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: SETPOINTS