Siemens SINUMERIK 840Di Manual page 278

10 NC Start-Up with HMI Advanced
10.2 Machine and setting data
Default
passwords
Redefining
protection levels
Data areas
Table 10-4 Protection levels: Machine data
Number
MMC machine data ($MM_....)
9200 USER_CLASS_READ_TOA
9201 USER_CLASS_WRITE_TOA_GEO
9202 USER_CLASS_WRITE_TOA_WEAR
9203 USER_CLASS_WRITE_FINE
9204 USER_CLASS_WRITE_TOA_SC
9205 USER_CLASS_WRITE_TOA_EC
9206 USER_CLASS_WRITE_TOA_SUPVIS
9207 USER_CLASS_WRITE_TOA_ASSDNO
9208 USER_CLASS_WRITE_MAG_WGROUP
9209 USER_CLASS_WRITE_TOA_ADAPT
9210 USER_CLASS_WRITE_ZOA
9213 USER_CLASS_OVERSTORE_HIGH
9214 USER_CLASS_WRITE_PRG_CONDIT
9215 USER_CLASS_WRITE_SEA
9218 USER_CLASS_SELECT_PROGRAM
9219 USER_CLASS_TEACH_IN
9220 USER_CLASS_PRESET
9221 USER_CLASS_CLEAR_RP A
9222 USER_CLASS_WRITE_RP A
9231 USER_CLASS_WRITE_RP A_1
9232 USER_BEGIN_WRITE_RPA_1
9233 USER_END_WRITE_RPA_1
9234 USER_CLASS_WRITE_RP A_2
10-278
The following default passwords are defined for the protection levels 1 though 3:
Protection level 1 SUNRISE
Protection level 2 EVENING
Protection level 3 CUSTOMER
Notice
A system power-up with loading the default machine data (after "Delete NCK
data", e.g. using 840Di Start-up) will reset the passwords to the default values.
In order to provide safe access protection, the default passwords should be
modified.
The protection levels of machine and/or setting data can be modified both with
respect to complete machine or setting data ranges and for single data.
Identifier
Protection level "Read tool offsets"
Protection level "Write tool geometry"
Protection level "Write tool wear data"
Protection level "Write fine"
Protection level "Change additive tool offsets"
Protection level "Change tool setup offsets"
Protection level "Change tool monitoring limit
values"
Change assigned D-No. of a tool edge
Change wear group magazine location/mag.
Protection level "Tool adapter data"
Protection level "Write settable zero offset"
Protection level "Extended overstore"
Protection level "Program control"
Protection level "Write setting data"
Protection level "Program selection"
Protection level "TEACH IN"
Protection level "PRESET"
Protection level "Delete R parameters"
Protection level "Write R parameters"
Protection level for the first RPA area
Start of the first RPA area
End of the first RPA area
Protection level for the second RPA area
Name
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
06.03
Ref.