GE C60 Instruction Manual page 146

5.6 CONTROL ELEMENTS
COUNTER 1 BLOCK:
Selects the FlexLogic™ operand for blocking the counting operation. All counter operands are blocked.
CNT1 SET TO PRESET:
Selects the FlexLogic™ operand used to set the count to the preset value. The counter will be set to the preset value in the
following situations:
1. When the counter is enabled and the
CNT1 SET TO PRESET
2. When the counter is running and the
changing from 1 to 0 while the counter is running has no effect on the count).
3. When a reset or reset/freeze command is sent to the counter and the
(when a reset or reset/freeze command is sent to the counter and the
the counter will be set to 0).
COUNTER 1 RESET:
Selects the FlexLogic™ operand for setting the count to either "0" or the preset value depending on the state of the
operand.
SET TO PRESET
COUNTER 1 FREEZE/RESET:
Selects the FlexLogic™ operand for capturing (freezing) the accumulated count value into a separate register with the date
and time of the operation, and resetting the count to "0".
COUNTER 1 FREEZE/COUNT:
Selects the FlexLogic™ operand for capturing (freezing) the accumulated count value into a separate register with the date
5
and time of the operation, and continuing counting. The present accumulated value and captured frozen value with the
associated date/time stamp are available as actual values. If control power is interrupted, the accumulated and frozen val-
ues are saved into non-volatile memory during the power down operation.
SETTING
COUNTER 1 FUNCTION:
Disabled = 0
Enabled = 1
SETTING
COUNTER 1 UP:
Off = 0
SETTING
COUNTER 1 DOWN:
Off = 0
SETTING
COUNTER 1 BLOCK:
Off = 0
SETTING
CNT 1 SET TO PRESET:
Off = 0
SETTING
COUNTER 1 RESET:
Off = 0
SETTING
COUNT1 FREEZE/RESET:
Off = 0
SETTING
COUNT1 FREEZE/COUNT:
Off = 0
5-82
CNT1 SET TO PRESET
is 0, the counter will be set to 0.)
CNT1 SET TO PRESET
SETTINGS
COUNTER 1 NAME:
AND COUNTER 1 UNITS:
COUNTER 1 PRESET:
RUN
CALCULATE
VALUE
SET TO PRESET VALUE
SET TO ZERO
AND
AND
OR
STORE DATE & TIME
OR
Figure 5–35: DIGITAL COUNTER SCHEME LOGIC
C60 Breaker Management Relay
operand has the value 1 (when the counter is enabled and
operand changes the state from 0 to 1 (
CNT1 SET TO PRESET
CNT1 SET TO PRESET
SETTING
COUNTER 1 COMPARE:
Count more than Comp.
Count equal to Comp.
Count less than Comp.
ACTUAL VALUE
COUNTER 1 ACCUM:
ACTUAL VALUES
COUNTER 1 FROZEN:
Date & Time
827065A1.VSD
5 SETTINGS
CNT1 SET TO PRESET
operand has the value 1
operand has the value 0,
CNT1
FLEXLOGIC
OPERANDS
COUNTER 1 HI
COUNTER 1 EQL
COUNTER 1 LO
GE Multilin