Update Method 2, Direct Connect Over The Ethernet Port - Motorola fx7400 Integrator Manual

Update Method 2, Direct Connect Over the Ethernet Port

Use this method to update a reader that is not on a LAN.
Use the serial
1.
(192.168.1.3).
Configure the host computer to reside on the same subnet as the reader:
2.
Open Network Connections and locate the connection to use to connect to the reader.
a.
Open the
b.
as the reader (192.168.1.5). Click OK.
TCP/IP Connection Properties Screen
Figure B-1
Connect the Cat5 crossover cable from the host computer to the reader.
3.
On the reader, access the web-based
4.
Open a browser and type http://192.168.1.3 (or the IP address of the reader to upgrade, if it is not the
a.
default address above). The
Reader on page
Enter the user name and password. If this is the first time accessing the console, a prompt appears for a
b.
user name and password update. The default settings are:
Username:
Password:
The
Console Main Menu
From the
5. Console Main Menu
Click the
6. Enable/Disable Polling
disabled.
Select
7. Maintenance
Maintenance chapter that was removed; remove step??]
Select
8. Version.
4-22. [refers to Maintenance chapter that was removed; remove step??]
to disable DHCP on the reader, and configure it for a static IP address
Administrator Console
TCP/IP Connection Properties
Administrator Console
Reader Administrator Console
4-3.
admin
change
appears. See
select
Scan Control
button to set to
. The
Reader Maintenance Console
The window displays the current version information. See
Version Control
Firmware Upgrade Procedures
window. Modify this to use a static IP address on the same subnet
:
login screen appears. See
Figure 4-14 on page 4-12.
. The
Reader Scan Control
. The button reads
Disable Polling
appears. See Figure 4-1 on page
Connect to the
screen appears.
if polling is
Enable Polling
4-2. [refers to
Figure 4-14 on page
B - 5