Sony DVP-NW50 Service Manual page 18

DVP-NW50
1-2. Verify the LAN Setup of the InWall Unit.
1. Turn the power on.
The HOME menu appears.
2. Press the "V" SELECT on the HOME Menu, then press the
"SETUP" SELECT.
The Setup Menu appears.
3. Press the "V" SELECT repeatedly until "LAN" appears on
the front panel display.
4. Press the "LAN" SELECT.
The LAN setup Menu appears.
5. Press the "IP ADDRESS" SELECT.
The IP address setup Menu appears.
• AUTO: You can acquire the IP address automatically.
Normally, select this setting.
Displayed IP ADDRESS is confirmed.
[At the use of a Broadband router]
(IP address) 192.168.aaa.bbb
(Subnet mask) 255.255.255.000
*2 The DHCP function of the router side must be effective.
The value of aaa.bbb is decided on the InWall Unit side
automatically.
It doesn't conflict with another unit similarly set as AUTO
if correctly connected and set.
[At the use of HUB]
(IP address) 169.254.xxx.yyy
(Subnet mask) 255.255.000.000
*3 The value of xxx.yyy is decided on the unit side
automatically.
It doesn't conflict with another unit similarly set as AUTO
if correctly connected and set.
18
t (IP address)
t (Subnet mask)
* 2
* 3
6. Press "AUTO" or "STATIC" SELECT.
• STATIC: You can set up the IP address manually.
Because some knowledge of networking is required
to use this setting, we recommend you normally to
select "AUTO."
Set IP ADDRESS is confirmed.
[At the use of a Broadband router]
(IP address) 192.168.aaa.bbb
(Subnet mask) 255.255.255.000
*4 The DHCP function of the router side must be effective.
The value of aaa.bbb is decided on the unit side
automatically.
It doesn't compete with another unit similarly set as AUTO
if correctly connected and set.
[At the use of HUB]
Not use with STATIC. Please go with AUTO.
t (IP address)
t (Subnet mask)
* 4