Faults / Troubleshooting - Siemens FT2010 Operation Manual

8 Faults / Troubleshooting

'Fault'
'Automatic detector'
'Manual call point'
'Mains failure'
Building Technologies
Fire Safety
If the 'Site' displays a 'Fault', the table below provides a list of all possible 'Faults',
including information on the possible causes.
If a 'Fault' cannot be eliminated with the help of these operation instructions, please
contact the service engineer.
Cause
'Detector' missing
'Detector' defective
Glass pane broken
Other damages
''Mains failure' in the public
network
Fuse damaged
With all other 'Faults', the service provider in account must be contacted.
Remedy
'Detector'
'Detector' with replacement detector.
CAUTION! Any defective 'Detector' must always be replaced
by a 'Detector' of the same type.
Replace glass pane
Contact service provider
No action required.
Emergency power supply is ensured by batteries during at
minimum 12 hours; depending on the customer specification
up to 72 hours.
Check fuses (current distributor of the building) and replace
them if necessary.
Faults / Troubleshooting
009310_i_en_--
2013-11-14
8
33