Standards And Directives Complied With; Cpr Conformity And Firmware Version; Release Notes - Siemens FT2010 Operation Manual

2.3 Standards and directives complied with

2.3.1

2.4 Release Notes

Building Technologies
Fire Safety
A list of the standards and directives complied with is available from your Siemens
contact.

CPR conformity and firmware version

In order to satisfy Ordinance No. 305/2011 (the Construction Products Regulation –
CPR), the firmware of a newly installed fire detection installation must be current
market package version MP5 / IP5 or higher.
NOTICE
Firmware version of a newly installed fire detection installation not updated
No CPR conformity
Compare the firmware version of a newly installed fire detection installation
with the firmware version MP5 / IP5.
Update the firmware if necessary.
Limitations to the configuration or use of devices in a fire detection installation with
a particular firmware version are possible.
WARNING
Limited or non-existent fire detection
Personal injury and damage to property in the event of a fire.
Read the 'Release Notes' before you plan and/or configure a fire detection
installation.
Read the 'Release Notes' before you carry out a firmware update to a fire
detection installation.
NOTICE
Incorrect planning and/or configuration
Important standards and specifications are not satisfied.
Fire detection installation is not accepted for commissioning.
Additional expense resulting from necessary new planning and/or configuration.
Read the 'Release Notes' before you plan and/or configure a fire detection
installation.
Read the 'Release Notes' before you carry out a firmware update to a fire
detection installation.
Standards and directives complied with
Safety 2
13
009310_i_en_--
2013-11-14