Faults / Troubleshooting - Siemens FT2010 Operation Manual

Faults / Troubleshooting

8
8 Faults / Troubleshooting
'Fault' Cause
'Automatic detector' 'Detector' missing
'Detector' defective
'Manual call point' Glass pane broken
Other damages
'Mains failure' 'Mains failure' in the public
network
Fuse damaged
34 | 40
Building Technologies
Fire Safety
If the ↑ 'Site' displays a 'Fault', the table below provides a list of all possible
'Faults', including information on the possible causes.
If a 'Fault' cannot be eliminated with the help of these operation instructions, please
contact the service engineer.
With all other 'Faults', the service provider in account must be contacted.
Remedy
Re-insert 'Detector'
Replace 'Detector' with replacement detector.
CAUTION! Any defective 'Detector' must always be
replaced by a 'Detector' of the same type.
Replace glass pane
Contact service provider
No action required.
Emergency power supply is ensured by batteries during
at minimum 12 hours; depending on the customer
specification up to 72 hours.
Check fuses (current distributor of the building) and
replace them if necessary.
009310_l_en_--
2018-08-29