Hitachi IJ RX2 Technical Manual page 60

(2) Operating procedure
Press Communication environment setup from the Environment setup menu.
1
The "Communication environment setup" screen appears.
Comm. env. setup
State at power-up
Communication and signal error
＜Transmission condition by port＞
Target port
Baud rate (bps)
＜Data format＞
Data length
Parity bit
Stop bits
＜Standard communication＞
Number of comm. bytes
BCC code handling
Communication mode
Print message transfer ACK
Print spec transfer char height
Press Next settings .
2
The second screen appears.
Comm. env. setup
Buffer function
Buffer repeat count
Empty Buffer Fault
Timing of Fault
Data Number at Fault
5-4 ●Setting Communication Environment
[Stop ]
Com=0
Comm. port in ON
Warn. Fault
Standard port
4800
7 bits
8 bits
Disable
1 bits 2 bits
1 byte 2 bytes
Enable
Disable
overwrite-protected overwrite-enabled
t=fixed
t=async.
2 digits 3 digits
[Stop ]
Com=0
Enable
Disable
０００１ (1∼9999)
Disable Enable
Print Start Print. Complete
0 (0∼9)
Setting of communication buffer
(Refer to " 5.9 Communication buffer".)
2015.07.07 12:45
M
Manual Startup
Change the on-line
HOME
or off-line.
Prev.Dsp. Next Dsp.
Back
2015.07.07 12:45
M
Startup
Manual
HOME
Prev.Dsp. Next Dsp.
Back