Figure 9-14
9.3.3
Mounting
Installation steps
1. Make an installation cutout and drill holes for the Power Module and the mounting frame
2. Fasten the mounting frame to the outer wall of the cabinet. Tighten the two screws finger-
3. Attach the seal to the inner side of the control cabinet.
4. Fasten the Power Module. Tighten the screws finger-tight.
5. Tighten all screws with a torque of 3.5 Nm.
6. To fulfill EMC requirements, the mounting surface of the heat sink must be free of any
AC Drive
Manual, (GH6), 04/2014, 6SL3097-4AL00-0BP4
Dimension drawing of mounting frame, frame size FSC, all data in mm and (inches)
according to the drilling pattern.
tight.
paint.
Accessories
9.3 Mounting frame
403