Fig. 4-2
4. You changed the data OFFLINE and now have to load it to the target system.
Carry out the following:
– Click <–– Load to target system in the "ONLINE/OFFLINE comparison"
dialog box.
– When the system asks "Are you sure?", click Yes. The system now starts
loading the data.
– When the system informs you that the data was successfully loaded to the
target system, click OK.
– Click OK for "Load from RAM to ROM".
5. Discrepancies were identified again during the ONLINE/OFFLINE comparison.
Click Load to PG ––> (see screenshot below).
Fig. 4-3
6. Load the new data from the drive unit to the PG. Carry out the following:
– When the system asks "Are you sure?", click Yes. The system now starts
loading the data.
Siemens AG 2006 All rights reserved
SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 03/2006 Edition
Using the STARTER Control Panel (Motor Rotates)
ONLINE/OFFLINE comparison, load to target system
ONLINE/OFFLINE comparison, load to PG
4-57