Default Values; Setting/Recalling The Setup Menu - Sony PCM-7040 Operation Manual

7-1 About the Menus
7-1-2 Setting the Display and
Settings to the Default Values
When using the expanded menu, you will select many
menus, usually sequentially. But you can go back
quickly to the first menu if that saves time. You can
also reset all the settings to the default (factory-set)
values together.
Setting back to the factory-set status
1
Turn the search dial while holding down the
MENU key until an item of the setup menu
appears in the display.
2
Press the RESET key while holding down the
MENU key.
The tape direction lamps light up to indicate the
display is set back to the default status.
Setting the display back to the default
condition
Press the DISPLAY key while holding the MENU key
down.
The display is set back to the default condition. At the
same time, doing this operation sets the dial menu
back to the "in Pt" menu though its menu display does
not appear on the display.
7-2
Chapter 7 Menu Operations
7-1-3 Setting/Recalling the Setup
Menu
Storing customized data for the setup
menu
Stores customised data you have chosen for each setup
menu. The data is stored from address 1 to address 10.
2 1
Once storing the data, then you can select one of the
10 addresses to store your parameters and operate the
unit using your own setup data.
1
Turn the search dial while holding the MENU key
down and set the display to "- - Sto - -".
2
Turn the search dial while holding the DATA key
down to select storing address.
3
Press the SET key.
Flashing stops and the setup data of each setup
menu are stored in the selected address.
You can store the following data:
• The upper limit of the input gain
• cross fade time
• setup menu
1
3 1,2