Sony PCM-7040 Operation Manual page 26

Connecting with RM-D7300
The editing ability of the system works most
efficiently when this unit is used as a recorder and a
player with the RM-D7300 Digital Audio Editor as an
editing controller. A configuration example is shown
below.
TIME CODE OUTPUT
TIME CODE INPUT
DIGITAL OUTPUT
DIGITAL INPUT
Switch settings
REMOTE (9P)/LOCAL selector
(on the front panel): REMOTE
SYNC signal selector
(on the front panel): EXT
Setup menu setting
din Sync (DIN SYNC): on
rcL (RECALL): d 7300
Digital audio signal
Digital audio signal
WORD SYNC
INPUT
Player
REMOTE (9P)
Remote control signals
3)
1)
4)
Time code
Time code 4)
Word sync signal 2)
DIGITAL INPUT
REMOTE (9P)
Remote control signals
Switch settings
REMOTE (9P)/LOCAL selector
(on the front panel): REMOTE
AUDIO INPUT selector
(on the front panel): DIGITAL
SYNC signal selector (on the front panel): INT
Setup menu setting
rcL (RECALL): d 7300
S302 setting on the Board SSP-11
No 3: ON
5)
No 4: OFF
RM-D7300
1) This signal is used as the sync signal from the
recorder to the player.
2) This signal can be a substitute for sync signal 1).
When this signal is used, set "din Sync"
(DIN SYNC) to oFF in the setup menu.
3) Use the recorder as a controlling device.
4) Connect time codes.
5) Set the device type to "PCM-7050".
DIGITAL
OUTPUT
TIME CODE
INPUT
TIME CODE
OUTPUT
WORD SYNC
OUTPUT
Recorder
3)
3-7
Chapter 3 Preparations