Name Of Pf611 Module Components And Parts - Toshiba 2000 User Manual

Chapter 2 Configuration

2.4 Name of PF611 Module Components and Parts

2
Status LED
Transmission cable
terminating resistor
specification switch
Mode 2
setup switch
•
•
Stop
Resume 1
Resume 2
Setting other than above will result in module failure.
MD4 to 7 are all set to "OFF" at shipment.
6
Configurator
port
Transmission
cable
connector
Reset switch
Figure 2-5 Name of components and parts
Mode 1 setup switch (hexadecimal rotary switch)
Used to specify module internal operation.
Set to "4" for PF611 (Shipment setting is "4").
Mode 2 setup switch (binary DIP switch)
Used to set the transmission status when there is a controller error.
Mode MD4 MD5
OFF OFF OFF
ON OFF OFF
ON ON OFF
Table 2-1 Mode 2 setup switch
MD6 MD7
OFF Stops transmission.
OFF Resumes transmission using the transmission data
prior to error.
OFF Resumes transmission using 0 as transmission
data.
model 2000 PROFIBUS Module User's Manual for S2T/S2E
Mode 1
setup switch
Transmission Status