Replacing The Hydraulic-Pump Drive Belt - Toro 74909TE Operator's Manual

Figure 86
1. Clutch pulley
2. Mower belt
3. Spring-loaded idler pulley
4. Ratchet
12. Install the belt guide on the idler arm shown in
86.
13. Using the ratchet in the square hole, install the idler
spring (Figure 86).
Note: Make sure that the spring ends are seated in
the anchor grooves.
14. Install the belt covers and the bolts attached to them
(Figure 87).
5. Square hole in the idler
arm for the ratchet
6. Idler grease fitting
7. Belt guide
Figure
1. Position the belt cover.
2. Slide belt cover under the
side catches.
Replacing the Hydraulic-Pump
Drive Belt
1. Disengage the blade-control switch (PTO) and set the
parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the mower belt; refer to
Belt (page 54).
4. Raise the machine and support it with jack stands
(Figure 88).
55
Figure 87
3. Tighten the bolt.
Replacing the Mower