Lubrication; Adding Light Oil Or Spray Lubrication; Greasing The Mower - Toro 74909TE Operator's Manual

Lubrication

Grease more frequently when operating conditions are
extremely dusty or sandy.
Grease Type: No. 2 lithium or molybdenum grease
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag.
Note: Make sure to scrape any paint off the front of
the fitting(s).
4. Connect a grease gun to the fitting and pump grease
into the fittings until grease begins to ooze out of the
bearings.
5. Wipe up any excess grease.
Adding Light Oil or Spray
Lubrication
Service Interval: Every 100 hours
Lubricate the deck-lift pivots.
Figure 49
- position,
EUTRAL LOCK
g035390
37

Greasing the Mower

Service Interval: Every 50 hours—Grease the mower-deck
spindles and idler arm.
Yearly—Grease the pump-belt idler arm.
Yearly—Grease the front caster pivots (more often in
dirty or dusty conditions).
Yearly—Repack the front caster-wheel bearings (more
often in dirty or dusty conditions).
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Loosen the bottom bolt holding the mower-deck
curtain to the mower deck. Refer to
Mower-Deck Curtain (page
4. Remove the sheet-metal guard. Refer to
Sheet-Metal Guard (page
5. Grease the mower-deck idler-pulley pivot until grease
comes out the bottom
6. Grease the 3 spindle bearings until grease comes out
the lower seals (Figure
Figure 50
- position,
EUTRAL LOCK
Releasing the
36).
Removing the
36).
(Figure 50).
50).
G009029