Adjusting The Anti-Scalp Rollers - Toro 74909TE Operator's Manual

Adjusting the Height-of-Cut Pin
Adjust the height-of-cut from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1. Move the transport lock to the L
2. Push on the deck-lift pedal with your foot and raise
the mower deck to the Transport position (also the
140 mm or 5-1/2 inch cutting-height position) as
shown in Figure 27.
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired, and insert the pin
27).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
Figure 27
1. Deck-lift pedal
2. Height-of-cut pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the height
of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Adjust the rollers to match the height of cut.
position.
OCK
(Figure 27).
(Figure
3. Transport lock
- position
EUTRAL LOCK
1. Anti-scalp roller
2. Spacer
3. Bushing
1. Anti-scalp roller
2. Bushing
1. Flange nut
2. Spacer
3. Bushing
26
Figure 28
4. Flange nut
5. Bolt
Figure 29
3. Flange nut
4. Bolt
Figure 30
4. Anti-scalp roller
5. Bolt