Table of Contents
Advertisement
Product Overview
1. Nose panel
2. Left side panel
3. Grab handles
4. ROPS enclosure
1. Grab handles
2. Right side panel
3. Nose panel
Figure 7
5. Fuel reservoir
6. Fuel cap
7. Steps
Figure 8
4. Steps
5. Hydraulic-fluid sight gauge
6. Hydraulic-tank cap
Controls
Become familiar with all the controls
16) before you start the engine and operate the machine.
Command Center
Home Screen Controls
Use the buttons on the command center to control the
operation of machine functions, and to navigate to the
machine setup and diagnostic screens
Home screen shown
1. Button 1 (light On/Off
button—used with the light
kit option)
2. Button 2 (increase the
set point for the load
control—used with the
load-control kit)
3. Button 3 (decrease the
set point for the load
control—used with the
load-control kit)
4. Button 4 (load control
On/Off—used with the
load-control option)
5. Button 5 (control
select—use to determine
which attachment the
backfill-blade/vibratory-plow
joystick operates)
6. Button 6
(advanced-steering
mode—used with the
advanced-steering kit)
7. Button 7 (increase the
engine speed)
15
(Figure 9
through
(Figure
9).
Figure 9
8. Button 8 (decrease the
engine speed)
9. Escape (used to return to
the home screen)
10. Previous screen (used to
move to a previous screen
function within a screen
mode)
11. OK (used to make a
selection)
12. Next screen (used to move
to the next screen function
within a screen mode)
13. Down screen (used to
move down to the previous
screen mode and enter
diagnostic and calibration
screens)
14. Up screen (used to move
up the next screen mode)
Figure
Advertisement
Table of Contents
