Table of Contents
Advertisement
Checking the Restricted
Air-Cleaner Indicator
Service Interval: Before each use or daily
1. Start the engine; refer to
33).
2. Check to see if the restricted air-cleaner indicator is
displayed in the home screen of the command center
(Figure
28).
1. Restricted air-cleaner
indicator
3. Replace the air-cleaner element(s) as follows:
A. Replace the primary air-cleaner element; refer to
Replacing the Air-cleaner Elements (page
B. Repeat steps
1
C. If the restricted air-cleaner indicator is still
displayed, replace the secondary air-cleaner
element; refer to
Elements (page
Inspecting the Machine
Service Interval: Before each use or daily
Inspect the following items on the machine each day before
you start the engine:
•
Check for leaks under the machine, and repair all leaks.
•
Check the tires for wear, damage, and low pressure.
•
Check the machine for debris, especially around the
engine.
Note: Ensure that the area near the engine is clean so
that the engine cools properly.
•
Clean or replace any safety or instructional decal that you
cannot read.
Operating the Engine (page
Figure 28
2. Command center
and 2.
Replacing the Air-cleaner
48).
•
Clean machine components that you use.
•
Remove any loose items from the machine.
•
Check the machine for broken, damaged, loose, or
missing parts. Replace, tighten, or adjust these parts
before you operate the machine.
•
Repair or replace all damaged ROPS and seat belt parts.
Operating the Command
Center
Software Messages
The command center will display information about the
controller version, display version, and installed optional
attachments or kits that are operated through the command
center. This information is displayed on the splash screen
during start up of the machine, as shown in A of
or when you access the main selection screen, as shown in B
of
Figure
29.
48).
1. Main controller version
2. Display version
26
Figure 29
Figure 29
3. Installed optional
attachments or kits
Advertisement
Table of Contents
