Servicing The Fuses; Drive System Maintenance; Checking The Seat Belt; Checking The Rollover-Protection-System (Rops) Knobs - Toro 74919TE Operator's Manual

Figure 63
1. Positive battery post
2. Negative battery post

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
1. The fuses are located on right hand console next to
the seat (Figure 64).
2. To replace the fuses, pull out on the fuse to remove it.
3. Install a new fuse (Figure
Figure 64
1. Optional accesory—15 A
2. Charge—25 A
3. PTO—10 A
3. Red (+) charger lead
4. Black (-) charger lead
64).
4. Main—25 A
5. Console
Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper operation of
the retractor and buckle. Replace the seat belt if it is damaged.
Checking the
Rollover-Protection-System
(ROPS) Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover: keep the roll
bar in the fully raised locked position and use the
seat belt.
Ensure that the seat is secured to the machine.
Check that both the mounting hardware and the knobs are in
good working condition. Make sure that the knobs are fully
engaged with the ROPS in the raised position. The upper
hoop of the roll bar may need to be pushed forward or pulled
rearward to fully engage both knobs
45
(Figure 65).