Panasonic KX-TDA100 Pc Programming Manual page 127

Programming Manual References
None
Feature Guide References
1.11.9 Parallelled Telephone
DPT Type—Type
Selects the port type. This setting is only available when Port Type on this screen is set to DPT or S-
Hybrid.
To change the port type of an extension port, follow the steps below:
1.
Set the status of the extension port to "OUS".
2.
Change the port type of the extension port, then click Apply.
3.
Set the status of the extension port to "INS".
When changing the port type of an extension port for which Wireless XDP has been set on the
2.11.1 [4-1-1] Wired Extension—Extension Settings screen, the Wireless XDP setting must
be deleted first.
When changing the type of a port for which one or more SDN buttons are set (except when
changing between PC Console and Telephone), all SDN buttons customised for that device will
be deleted. When you attempt to apply the new settings, a warning message is displayed
showing the slot and port number for which SDN buttons will be deleted. If you do not wish to
delete SDN buttons for this port, click Cancel.
Value Range
Normal: For connecting a DPT
DSS: For connecting a DSS Console (A maximum of 4 [with the KX-TDA30], 8 [with the KX-TDA100/
KX-TDA200] or 64 [with the KX-TDA600] DSS Consoles can be connected to the PBX.)
VM (DPT): For connecting a Panasonic VPS through DPT Integration
PC Console: For connecting a PC Console (A maximum of 2 [with the KX-TDA30] or 8 [with the KX-
TDA100/KX-TDA200/KX-TDA600] PC Consoles can be connected to the PBX.)
Maintenance Console Location
2.8.5 [1-1] Slot—Port Property - Extension Port
Programming Manual References
2.8.6 [1-1] Slot—Port Property - Extension Port—Connection Command
Feature Guide References
1.24.1 Voice Mail (VM) Group
1.32.1 Computer Telephony Integration (CTI)
DPT Type—Location No.
Specifies the location number of the connected DSS Console or PC Console. This setting is only
available when Port Type on this screen is set to DPT or S-Hybrid.
Note that, depending on system traffic, there may be a limit to the number of PC Consoles that can
be supported by a single DLC/DHLC card.
When changing the location number of a DSS Console for which one or more SDN buttons are set,
all SDN buttons customised for that device will be deleted. When you attempt to apply the new
2.8 [1] Configuration
PC Programming Manual 127