Snapshot Mode Timeout; Snapshot Aiming Pattern - Motorola PL3307 Integration Manual

5 - 14 PL3307 Decoder Integration Guide

Snapshot Mode Timeout

Parameter # F0h 43h
This parameter sets the amount of time the decoder remains in Snapshot Mode. The decoder exits Snapshot
Mode upon a trigger event, or when the Snapshot Mode Timeout elapses. To set this timeout value, scan the
bar code below followed by a bar code from
represents 30 seconds; values increment by 30. For example, 1 = 60 seconds, 2 = 90 seconds, etc.
Snapshot Mode Timeout

Snapshot Aiming Pattern

Parameter # F0h 2Ch
Select Enable Snapshot Aiming Pattern to project the aiming pattern when in Snapshot Mode, or Disable
Snapshot Aiming Pattern to turn the aiming pattern off.
Disable Snapshot Aiming Pattern
(00h)
Appendix D, Numeric Bar
*Enable Snapshot Aiming Pattern
Codes. The default value is 0 which
(01h)