Chapter 5 Imaging Preferences; Introduction - Motorola PL3307 Integration Manual

CHAPTER 5 IMAGING PREFERENCES

Introduction

You can program the decoder to perform various functions, or activate different features. This chapter
describes imaging preference features and provides programming bar codes for selecting these features.
NOTE Only the Symbol Native API (SNAPI) with Imaging interface supports image capture. See
Type on page 6-3
The decoder ships with the settings in
Standard Default Parameters
requirements, programming is not necessary.
There are two ways to change a parameter value:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory.
•
For SSI and USB SNAPI hosts, send a "parameter send" command from the host system. Hexadecimal
parameter numbers appear in this chapter below the parameter title, and options appear in parenthesis
beneath the accompanying bar codes. See the Simple Serial Interface (SSI) Programmer's Guide for
detailed instructions for changing parameter values using this method.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
Select a host type (see each host chapter for specific host information) after the power-up beep signal
activates. This is only necessary upon the first power-up when connected to a new host.
To return all features to default values, scan the
programming bar code menus, asterisks (
*
to enable this host.
Imager Preferences Default Table on page 5-2
for all host device and miscellaneous defaults). If the default values suit
*
*
Enable Decode Aiming Pattern
Indicates Default
Set Default Parameter on page
) indicate default values.
(02h)
USB Device
(also see Appendix A,
4-5. Throughout the
Feature/Option
Option Hex Value