Serial Host Parameters - Motorola PL3307 Integration Manual

Serial Host Parameters

Various serial hosts use their own parameter default settings. Selecting standard, ICL, Fujitsu, Wincor-Nixdorf
Mode A, Wincor-Nixdorf Mode B, OPOS/JPOS, Olivetti, Omron, or Common Use Terminal Equipment
(CUTE-LP/LG bar code readers) sets the defaults listed in
Terminal Specific RS-232
Table 8-2
Parameter
Baud Rate
Parity
Stop Bits
ASCII Format
Hardware
Handshaking
Software
Handshaking
Serial Response
Time-out
RTS Line State
Beep On <BEL>
Transmit Code ID
Data Transmission
Format
Prefix
Suffix
In the Nixdorf Mode B, if CTS is low, scanning is disabled. When CTS is high, scanning is enabled.
If you scan Nixdorf Mode B without connecting the decoder to the proper host, it may appear
unable to scan. If this happens, scan a different serial host type within 5 seconds of cycling power
to the decoder.
The CUTE host disables all parameter scanning, including Set Defaults. If you inadvertently select
CUTE, scan *Enable Parameter Scanning (01h) on page 4-6, then change the host selection.
Wincor-
ICL Fujitsu
9600 9600 9600
Even None Odd
One One One
8-Bit 8-Bit 8-Bit
RTS/CTS None RTS/CTS
Option 3 Option 3
None None None
9.9 Sec. 2 Sec. None
High Low Low
Disable Disable Disable
Yes Yes Yes
Data/Suffix Data/Suffix Data/Suffix
None None None
CR (1013) CR (1013) CR (1013)
Table 8-2.
Wincor-Nixdorf
Nixdorf Mode B/
Mode A OPOS/JPOS
9600
Odd
One
8-Bit
RTS/CTS
Option 3
None
None
Low = No data to
send
Disable
Yes
Data/Suffix
None
CR (1013)
Serial Interface
Olivetti Omron CUTE
9600 9600 9600
Even None Even
One One One
7-Bit 8-Bit 7-Bit
None None None
ACK/NAK None None
9.9 Sec. 9.9 Sec. 9.9
Sec.
Low High High
Disable Disable Disable
Yes Yes Yes
Prefix/Data/ Data/ Prefix/
Suffix Suffix Data/
Suffix
STX (1002) None STX
(1002)
ETX (1003) CR (1013) CR
(1013)
ETX
(1003)
8 - 3