3.10.3
Adjustment of skew
When an image skew occurs, adjust it according to the following steps, Step 1 Step 2 Step 3.
Note:
Note:
Perform this adjustment after confirming that the equipment has been adjusted properly.
Prior to this adjustment, of RADF position and height are needed to be adjusted.
(1)
Step 1
Case A:
Adjust the aligning adjustment position to the rear side "-" of the original ( P.3-63 "3.10.5
Adjustment of aligning").
Case B:
Adjust the aligning adjustment position to the rear side "+" of the original ( P.3-63 "3.10.5
Adjustment of aligning").
A
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
ADJUSTMENT
Paper
Original
Fig. 3-65
3 - 60
B
White arrow: feeding direction
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved