3.13.4
After replacing the EEP-ROM (IC1002) (Electrical system
(Puncher unit; option))
<Procedure>
(1)
Turn off the host machine.
(2)
Set bits 1 through 4 on the punch controller PCB as follows:
(3)
Press SW1002 and SW1003 on the punch controller PCB at the same time.
•
The presses will initialize the EEP-ROM. At the end, all LEDs (LED1001, LED1002,
LED1003) will go ON.
(4)
Adjust the sensor output, and store the number of punch holes.
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
ON
1
2
3
4
Fig. 3-132
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
3 - 99
3
ADJUSTMENT