Panasonic DBS Section 540 Reference Manual page 73

Quick-Start Programming
Network Paging Assignments
(If not using Network Paging, skip steps 17-22. However, please read the note
with step 18.)
17. Enable Network Paging for one or more Class of Service. (See Table 2-
Address
Options
18. Assign an appropriate Class of Service to each extension to allow or deny
Address
Options
Note
19. Assign an appropriate Class of Service to the Network Trunk Group to
Address
Options
Note
20. Set the outgoing dial type to DTMF. DTMF is required for Network
Address
Options
Note
DBS-2.3/9.2-540
17 on page 24 and following tables.)
FF1 2# 5# (COS No.)# 22# (0-1)#
0=Network paging not allowed
1=Network paging allowed
the origination of a network page.
FF3 (Ext. Port No.)# 35# (0-8)#
0 - 8 Class of Service Number (0 default)
COS 0 enables all features including network paging. To
prevent network paging, assign the extension a COS other
than 0 that denies network paging.
allow or deny the receiving of a network page. (See Table 2-21 on page
25 and following tables.)
FF1 8# 4# 8# 3# (NWG)# 22# (COS)#
0 - 8 Class of Service Number (0 default)
This assigns a class of service to the Network Trunk Group.
The only class of service item considered is incoming net-
work paging allow or deny.
Paging.
FF1 8# 4# 8# 3# (NWG)# 1# (0/1)#
0=Rotary Dial (Pulse Dial)
1=DTMF
DTMF must be enabled for Network Paging operation.
The DBS must be equipped with one or more MFR cards.
Note: The above command requires a system restart to take effect.
T1 Networking - Revised April 2000
Programming Initial T1 Network Options
Page 73