Replacing Cards - Samsung OfficeServ 7100 Installation Manual

OfficeServ 7100
TECHNICAL MANUAL

3.3.2 Replacing Cards

Removing Cables
Replace a card after removing all cables connected to the card.
The procedure for replacing a card is as follows:
POWER TO THE CABINET MUST BE TURNED OFF BEFORE REMOVING CARDS.
Failure to do so will damage the card, cabinet and/or corrupt the data moving along
the data bus.
1) Turn off system power using the power switch in the back of the system.
2) Extract the card by pulling the lever of the card carefully.
3) Align the new card to the guardrail of the slot, and slide the new card into the slot. Then
lock the lever in the front panel of the card to fully secure into the connector of the
OfficeServ 7100 main card.
Figure 3.10 Turning the Cabinet Power Off
Figure 3.11 Removing a Card
3.13
Home Page Table of Contents
INSTALLATION
PART 3 MAY 2010