OfficeServ 7100
TECHNICAL MANUAL
PART 3. INSTALLING AND REPLACING CARDS
This section describes how to install and replace various cards of the OfficeServ 7100 system.
3.1 CABINET CONFIGURATION
The OfficeServ 7100 system has 3 slots (slots 0~2). Slot 0 is a processor slot only used for
either the MP10/MP10a processor card. Slots 1 and 2 are universal slots for station and trunk
interface cards as described below.
Front
Rear
Following cards are allowed to be installed in the 7100 as shown below:
NOTE: ONLY THESE CARDS ARE ALLOWED IN THE SPECIFIED SLOTS. ALL OTHER CARDS
ARE NOT ALLOWED IN THE OS7100 SYSTEM.
Slot
Slot 0
(processor slot)
Slot 0
Slot 1
Figure 3.1 Front/Rear View of OfficeServ 7100 Cabinet
Table 3.1 Card Installation Configuration
Cards Allowed
MP10/MP10a ONLY
3.1
Home Page
Slot 2
Table of Contents
INSTALLATION
PART 3 MAY 2010