Camp-On (Call Waiting) - Panasonic DBS576 Technical Manual

Chapter 5. Key Telephone Features
To store the Call Log number in a personal speed dial:
1. Go off-hook or press the ON/OFF key.
2. Dial the Call Log feature code (default = CONF 96).
3. Press the following keys to view the call log:
# - Move forward in call log
* - Move back in call log
NEXT - View the next 5 calls
PREV - View the previous 5 calls
4. To store the call log number in a personal speed dial:
Press the PROG key, the speed dial bin number (80-99) and
press the left Soft key (to dial the add digits, usually an area
code) and press the HOLD key.
OR...
Press the PROG key, the speed dial bin number (80-99) and
press the right Soft key and press the HOLD key.
Hardware Requirements
• Caller ID daughter circuit card on the Loop Start Trunk Card if a Loop Start Trunk receives the
call.
• ISDN (PRI-T Point) if ISDN card receives the call.
• Large Display Telephone or 44-Series Small Display Telephone.
Related Programming
• FF1-0-01-0021: Caller ID Log Outgoing
• FF1-0-01-0022: Caller ID Log Control for Private or Out of Area
• FF8-1-10: Set Caller ID Logging Extensions
Considerations
• Caller ID is available ISDN PRI.
• Caller ID circuit card must be installed and enabled. (See "Caller ID" on page 3-10).
• Caller ID is typically 10 digits. If the local calling area requires 7-digit dialing, the call log
outdialing will not operate properly.

Camp-on (Call Waiting)

Description
If you dial a busy extension, you can camp onto that extension and send a Call Waiting signal to the
called party. The called party then needs only to replace the handset and pick it up again to be
automatically connected to the new call. The called party can also press the HOLD key to place the
first call on hold and then answer the waiting call.
5-34
Action
DBS 576 (USA) issued October 2000
Section 700 - Operation
Result
Intercom dial tone
Phone enters call log mode.
576-36-700